Operation CHARM: Car repair manuals for everyone.
Home >> Subaru >> 2001 >> Impreza Outback Sport AWD F4-2.2L SOHC >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Restraints and Safety Systems >> Air Bag Control Module >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Air Bag Control Module: Service and Repair

REMOVAL

CAUTION:




- Do not disassemble the airbag control module.




- If the airbag control module is deformed, or if water damage is suspected, replace the airbag control module with a new genuine part.




- After removal, keep the airbag control module on a dry, clean surface away from heat and light sources, and moisture and dust.

1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove lower cover.
4. Disconnect airbag connector (AB3) and (AB8) below steering column.






CAUTION: Do not reconnect airbag connector at steering column until airbag control module is securely re-installed.

5. Remove instrument panel console.
6. Disconnect connector from airbag control module.
7. Using T40 TORX(R) bit (Tamper resistant type), remove four TORX(R) bolts in numerical sequence shown in figure. Discard the old TORX(R) bolts.






CAUTION: Use new TORX(R) bolts during re-assembly.

INSTALLATION
Install in the reverse order of removal.
pro multis · About Operation CHARM