Real-Time Diagnosis

1. Connect the select monitor.
2. Turn the ignition switch and cruise control main switch to ON.
3. Turn the Subaru Select Monitor switch to ON.
4. On the Main Menu display screen, select the (Each System Check) and press the [YES] key.
5. On the System Selection Menu display screen, select the (Cruise Control) and press the [YES] key.
6. Press the [YES] key after displayed the information of engine type.
7. On the Cruise Control Diagnosis display screen, select the (Current Data Display & Save) and press the [YES] key.
8. Make sure that normal indication is displayed when controls are operated as indicated below:
- Depress/release the brake pedal. (Stop light switch and brake switch turn ON.)
- Turn ON the "SET/COAST" switch.
- Turn ON the "RESUME/ACCEL" switch.
- Depress/release the clutch pedal. (MT)
- Set the selector lever to P or N. (AT)

NOTE:
- For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
- For detailed concerning diagnostic trouble codes, refer to the LIST OF DIAGNOSTIC TROUBLE CODE. Cruise Control - Diagnostics