Scan Tool Testing and Procedures
Subaru Select MonitorOPERATION
1. READ DIAGNOSTIC TROUBLE CODE (DTC)
1. Prepare the Subaru Select Monitor kit.
2. Connect the diagnosis cable to Subaru Select Monitor.
3. Insert the cartridge into Subaru Select Monitor.
4. Connect the Subaru Select Monitor to data link connector.
(1) Data link connector located in the lower portion of the instrument panel (on the driver's side).
(2) Connect the diagnosis cable to data link connector.
NOTE: Do not connect scan tools except for Subaru Select Monitor and OBD-II general scan tool.
5. Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
6. On the Main Menus display screen, select the (Each System Check) and press the [YES] key.
7. On the System Selection Menus display screen, select the {Transmission Control System} and press the [YES] key.
8. Press the [YES] key after displayed the information of transmission type.
9. On the Transmission Diagnosis display screen, select the {Diagnostic Code(s) Display} and press the [YES] key.
10. On the Diagnostic Code(s) Displays display screen, select the {Latest Diagnostic Code(s)} or {Memorized Diagnostic Code(s)} and press the [YES] key.
NOTE:
^ For detailed concerning diagnostic trouble codes, refer to the DIAGNOSTIC TROUBLE CODE LIST (DTC).
2. READ CURRENT DATA
1. On the Main Menus display screen, select the {Each System Check} and press the [YES] key.
2. On the System Selection Menus display screen, select the {Transmission Control System} and press the [YES] key.
3. Press the [YES] key after displayed the information of transmission type.
4. On the Transmission Diagnosis display screen, select the {Current Data Display & Save} and press the [YES] key.
5. On the Data Display Menus display screen, select the {Data Display} and press the [YES] key.
6. Using the scroll key, move the display screen up or down until the desired data is shown.
^ A list of the support data is shown in the following table.
3. CLEAR MEMORY MODE
1. On the <
3. Press the [YES] key after displayed the information of transmission type.
4. On the Transmission Diagnosis display screen, select the {Clear Memory} and press the [YES] key.
5. When the 'Done' end 'Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.