Transmission Speed Sensor: Service and Repair
Vehicle Speed SensorREMOVAL
1. Disconnect battery ground cable.
2. Lift-up the vehicle.
3. Remove front and center exhaust pipes.
4. Disconnect connector from vehicle speed sensor.
5. Turn and remove vehicle speed sensor.
INSTALLATION
NOTE:
^ Discard vehicle speed sensor and after removal, replace with a new one.
^ Ensure sensor mounting hole is clean and free of foreign matter.
^ Align tip end of key with key groove on end of speedometer shaft during installation.
1. Hand tighten vehicle speed sensor.
2. Tighten vehicle speed sensor using suitable tool.
Tightening torque: 5.9 Nm (0.6 kgf-cm, 4.3 ft. lbs.)
3. Connect connector to vehicle speed sensor.
4. Install front and center exhaust pipes.
5. Lower the vehicle.
6. Connect battery ground cable.