Security Control Module

Security Control Module

REMOVAL

1. Disconnect the ground cable from battery.
2. Remove front cover (A).




3. Remove screws (B) and then detach center panel (C) while disconnecting connector.




4. Remove two screws.

NOTE: Before removing the screw, apply a few turns of butyl tape to the tip of the service tool. This prevents the screw from falling during removal.

5. Remove radio and security control module together while disconnecting connector.

INSTALLATION

Install in the reverse order of removal.

NOTE: To install the security control module, tighten the bolts securely so that the bolts do not come loose.