Fuel Filter: Service and Repair

Fuel Filter

A: REMOVAL

WARNING:
- Place "NO FIRE" signs near the working area.
- Be careful not to spill fuel on the floor.

NOTE The fuel filter is built in fuel pump assembly.
1) Release the fuel pressure. Start engine and run it until it stalls. After the engine stalls, crank it for five more seconds. Turn ignition switch OFF.

2) Remove the fuel pump assembly.
3) Disconnect the ground cable from filter holder.






4) Remove the filter holder by turning it to the left from the body pawls, and then take out the filter.






B: INSTALLATION

NOTE:
- If the fuel hoses are damaged at the connecting portion, replace it with a new one.
- If the clamps are badly damaged, replace with new ones.
- Replace the 0-ring with new ones.

1) Set the 0-ring on the filter holder, and then install by turning to the right.






2) Connect the ground cab~e to filter holder.
3) Install the fuel pump assembly.

C: INSPECTION
1) Check the inside of fuel filter for dirt and water sediment.
2) If it is clogged, or if replacement interval has been reached, replace it.