Select Cable
Select CableADJUSTMENT
1. Set the vehicle on a lift.
2. Set the lever to "N" position.
3. Lift-up the vehicle.
4. Remove the rear exhaust pipe and muffler.
5. Remove the heat shield cover. (If equipped)
6. Loosen the adjusting nut on each side.
7. Turn the adjusting nut B until it lightly touches the connector.
8. While preventing the adjusting nut B from moving with a wrench, tighten the adjusting nut A.
Tightening torque: 7.5 Nm (0.76 kgf-m, 5.5 ft. lbs.)
9. After completion of fitting, make sure that the select lever operates smoothly all across the operating range.
10. Install in the reverse order of removal.