Cruise Cancel Conditions Diagnosis

CRUISE CANCEL CONDITIONS DIAGNOSIS




1. Prepare Subaru Select Monitor kit.
2. Connect diagnosis cable to Subaru Select Monitor.




3. Insert cartridge into Subaru Select Monitor.
4. Connect Subaru Select Monitor to data link connector.




1. Data link connector (A) is located in the lower portion of the instrument panel (on the driver's side).
2. Connect diagnosis cable to data link connector.

5. Start engine and turn cruise control main switch to ON.




6. Turn Subaru Select Monitor switch (A) to ON.

7. On the Main Menu display screen, select the {All System Diagnosis} and press the [YES] key.

NOTE: The diagnostic trouble code (DTC) is also shown in the {Each System Check} mode. This mode is called up on the "Cruise Control Diagnosis" display screen by selecting the item {Cancel Code(s) Display}.

8. Drive vehicle at least 40 km/h (25 MPH) with cruise speed set.
9. If cruise speed is canceled itself (without doing any cancel operations), a diagnostic trouble code (DTC) will appear on select monitor display.

CAUTION:
- A diagnostic trouble code (DTC) will also appear when cruise cancel is effected by driver. Do not confuse.
- Have a co-worker ride in vehicle to assist in diagnosis during driving.

NOTE: Diagnostic trouble code (DTC) will be cleared by turning ignition switch or cruise control main switch to OFF.