With Manufacturer's Scan Tool

Clear Memory Mode

OPERATION

SUBARU SELECT MONITOR (NORMAL MODE)

1. On the Main Menu display screen, select the {2. Each System Check} and press the [YES] key.
2. On the System Selection Menu display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after displayed the information of engine type.
4. On the Engine Diagnosis display screen, select the {Clear Memory} and press the [YES] key.
5. When the `Done' and `Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.

NOTE:
- After the memory has been cleared, the ISC must be initialized. To do this, turn the ignition switch to the ON position. Wait 3 seconds before starting the engine. (AT vehicles only)
- For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.

SUBARU SELECT MONITOR (OBD MODE)

1. On the Main Menu display screen, select the {2. Each System Check} and press the [YES] key.
2. On the System Selection Menu display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after displayed the information of engine type.
4. On the Engine Diagnosis display screen, select the {OBD System} and press the [YES] key.
5. On the OBD Menu display screen, select the {4. Diagnosis Code(s) Cleared} and press the [YES] key.
6. When the 'Clear Diagnostic Code?' is shown on the display screen, press the [YES] key.
7. Turn Subaru Select Monitor and ignition switch to OFF.

NOTE:
- After the memory has been cleared, the idle air control solenoid valve must be initialized. To do this, turn the ignition switch to the ON position. Wait 3 seconds before starting the engine.
- For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.