Brake Light Switch: Adjustments
Stop Light SwitchADJUSTMENT
Loosen the lock nut, and adjust the stop light switch position until the clearance between threaded end of stop light switch and stopper (A) becomes 0.3 mm (0.012 inch). Then, tighten the lock nut.
Tightening torque: 8 Nm (0.8 kgf-m, 5.8 ft. lbs.)
NOTE: Tighten the lock nut (B) until the clearance between threaded end of stop light switch and stopper becomes 0 mm (0 inch). Hold the stop light switch to prevent turning, and then loosen the lock nut (B) approximately 60 degrees. The clearance will become 0.3 mm (0.012 inch).