Gear Sensor/Switch: Service and Repair

Switches and Harness

REMOVAL
BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
1. Disconnect the ground cable from battery.
2. Remove the air intake duct and cleaner case.




non-turbo





Turbo Models

3. Disconnect the connector of back-up light switch and neutral position switch.
4. Lift-up the vehicle.





5. Remove the back-up light switch and neutral position switch with harness.

INSTALLATION
BACK-UP LIGHT SWITCH AND NEUTRAL POSITION SWITCH





1. Install the back-up light switch and neutral position switch with harness.
Tightening torque: 24.5 Nm (2.5 kgf-m, 18.1 ft. lbs.)
2. Connect the connector of back-up light switch and neutral position switch.
3. Install the air intake duct and cleaner case.
4. Connect the battery ground cable to battery.