Front Crossmember Support Plate

Front Crossmember Support Plate

REMOVAL
1. Lift-up the vehicle.
2. Remove the front under cover.
3. Remove the bolt and remove front Crossmember support plate.





^ Large type





^ Small type

INSTALLATION
Install in the reverse order of removal.

NOTE: Tighten the small type Crossmember support plate together with stabilizer bracket.

After installing the stabilizer bracket to crossmember, tighten the Crossmember support plate together.
Tightening torque:
Crossmember support plate: 60 Nm (6.1 kgf-cm, 44.3 ft. lbs.)
Crossmember support plate (Joint tightening portion of stabilizer bracket): 25 Nm (2.5 kgf-cm, 18.1 ft. lbs.)
Jack-up plate: 60 Nm (6.1 kgf-cm, 44.3 ft. lbs.)