Tire Monitoring System: Service and Repair

REGISTER TRANSMITTER ID

- Transmitter replaced
- Switched the position of the transmitter (rotated tires)
- Replaced the tire pressure monitoring control module.

NOTE:
- If registration of the transmitter ID is not possible after two attempts, replace the tire pressure monitoring control module.
- If the ignition switch and Subaru Select Monitor power are turned OFF while registering the transmitter, or if registration is not possible for more that 5 minutes, the registration mode is cancelled.
- When rotating tires, there is no affect on the performance or funtions of the tire pressure monitoring control module even if the transmitter (ID) is not registered, however, the tire position displayed on the Subaru Select Monitor will be incorrect.

1) Adjust all tire pressures to the specifications.

NOTE:
- Refer to the tire caution label on the driver's side door for the correct tire pressure.

2) Connect the Subaru Select Monitor, on the [[Main Menu]] display screen, select the {2. Each System Check} and press the [YES] key.
3) On the [[System Selection Menu]] display screen select the {Tire Pressure Monitor} and press the [YES] key.
4) Press the [YES] key after the {Tire Pressure Monitor} is displayed.
5) On the [[Tire Pressure Monitor Diagnosis]] display screen, select the {Transmitter ID regist confirm} and press the [YES] key.
6) {When ID registration mode execute, Registered ID is deleted Proceed?} is displayed then press the [YES] key.
7) Touch the transmitter registration tool to the side wall area near the air valve on the front left tire, and press the switch. The transmitter ID is sent to the tire pressure monitoring control module. (At that time, the tire pressure warning light blinks to confirm that the registration has started.)

NOTE:
- Register the transmitter ID in the order of Left Front --> Right Front --> Right Rear --> Left Rear.
- The transmitter registration tool is used by touching the side wall area near the transmitter.
- When registration of each tire is completed, the hazard light will blink and {ID registration completed} is displayed on the Select Monitor screen.
- If registration procedure stop in the halfway (turning ignition switch to OFF, wrong registration order, etc, proceed from step 5)

8) When ID registration is completed, the tire pressure warning light remains lit for approximately 2 seconds, to end the registration. Switch to the screen displaying the transmitter ID on the Subaru Select Monitor display.
9) Check the transmitter ID that was registered, then perform a driving test.

DISPLAY TRANSMITTER (ID).

1) On the [[Main Menu]] display screen, select {Each System Check} and press the [YES] key.
2) On the [[System Selection Menu]] display screen, select the {Tire Pressure Monitor} and press the [YES] key.
3) Press the [YES] key after the {Tire Pressure Monitor} is displayed.
4) On the [[Tire Pressure Monitor Diagnosis]] display screen, select the {Transmitter ID regist confirm} and press the [YES] key.
5) Select {Transmitter ID Data Monitor} and press the [YES] key to display the transmitter ID.