Rear Entertainment

Rear Entertainment

REMOVAL
1. Disconnect the ground cable from battery.




2. Insert a flat tip screw driver in the section, and remove the room lamp lens.




3. Remove the bolts, and then remove the monitor cover.




4. Remove the 4 mounting bolts.




5. Remove the temporary screws and remove the monitor body.

NOTE: Always support with one hand to prevent the unit from falling.

6. Remove the temporary clips from the roof brace.

INSTALLATION
1. Attach the temporary clip and temporary screw to the rear entertainment system body.

NOTE: When installing a new rear entertainment system, a clip is supplied on the unit, and this step can be omitted.

2. Place the hook of the rear entertainment unit on the roof brace section.
3. Affix the temporary fixture clips on the roof brace.
4. Tighten the 4 attachment bolts, and connect the connector.
5. Connect the room lamp connector, attach the cover and affix with the bolts.
6. Attach the room lamp lens from the outside of the vehicle and snap into place. Install in the reverse order of removal.