Without Scan Tool

CLEAR MEMORY MODE

Clear the DTC stored in the airbag control module after repairing malfunction in airbag system and occupant detection system. If the memory is not cleared after repairing malfunction, repaired DTC will be read out again when a new malfunction occurs.)
1. On the [Main Menu] display screen, select the {Each System Check} and press the [YES] key.
2. On the [System Selection Menu] display screen, select the {Airbag System} and press the [YES] key.
3. On the [Airbag System] display screen, select the {Clear Memory} and press the [YES] key.
4. Press the [YES] key after the Clear memory? has been displayed.
5. When the Done is shown on the display screen, turn the Subaru Select Monitor switch to OFF.

NOTE: For details concerning operation procedure, refer to the SUBARU SELECT MONITOR OPERATION.