Select Cable
ADJUSTMENT1) Set the vehicle on a lift.
2) Set the select lever to "N" range.
3) Lift up the vehicle.
4) Remove the rear exhaust pipe and muffler.
5) Loosen the adjusting nuts on both sides.
6) Turn the adjusting nut B until it lightly touches the connector.
7) Set a spanner wrench to adjusting nut B so that it does not rotate, and then tighten the adjusting nut A.
Tightening torque: 7.5 N-m (0.76 kgf-m, 5.5 ft-lb)
8) After completion of fitting, make sure that the select lever operates smoothly all across the operating range.
9) Install in the reverse order of removal.