Register Transmitter ID

Register Transmitter (ID)

1) Adjust all tire pressures to the specifications.
2) Connect Subaru Select Monitor and select (2. Each System Check) on the [Main Menu].
3) On the [System Selection Menu], select (Tire pressure monitor).
4) After the (Tire pressure Monitor). is displayed, select [OK].
5) On the [Tire pressure monitor diagnosis], select (Transmitter ID regist confirm).
6) [ID registration mode when execute, Registered ID is deleted. Continue?) is displayed, select [OK].
7) Touch the transmitter registration tool to the side wall area near the air valve on the front left tire, and press the switch. The transmitter ID is sent to the tire pressure monitoring control module. (At that time, the tire pressure warning light blinks to confirm that the registration has started.)





NOTE:
^ The registration order of transmitter ID is not specified.
^ The transmitter registration tool is used by touching the side wall area near the transmitter.
^ When registration of each tire is completed, the hazard light will blink and (ID registration completed) is displayed on the Select Monitor screen.
^ If registration procedure stop in the halfway (turning ignition switch to OFF, wrong registration order, etc), proceed from step 5)

8) When ID registration is completed, the tire pressure warning light remains lit for approximately 2 seconds, to end the registration. Switch to the screen displaying the transmitter ID on the Subaru Select Monitor display.
9) Check the transmitter ID that was registered, then perform a driving test.