Extension Case Oil Seal

REPLACEMENT

1) Lift up the vehicle.
2) Clean the transmission exterior.
3) Remove the drain plug (ATF) to drain the ATF.

CAUTION:
Because the AFT will be very hot after driving, be very careful not be receive burns.

4) Perform replacement with a new gasket, and tighten the drain plug (ATF).

Tightening torque: 25 N-m (2.5 kgf-m, 18.4 ft-lb)





5) Remove the rear exhaust pipe and muffler.
6) Remove the heat shield cover.





7) Remove the propeller shaft.
8) Using the ST, remove the oil seal.

ST 398527700 PULLER ASSY

9) Using the ST, install the oil seal.

ST 498057300 INSTALLER

10) Install the propeller shaft.
11) Install the heat shield cover.





12) Install the rear exhaust pipe and muffler.
13) Fill with ATF.
14) Bleed the air of control valve.
15) Check the level and leaks of the ATF.