Clearing Diagnostic Trouble Codes
CLEAR MEMORY MODE1) Shift the select lever to "P" range.
2) On [Main Menu] display, select (Each System Checks).
3) On [System Selection Menu] display, select (Transmission Control System).
4) After transmission type information pops up, select [OK].
5) On [Transmission Diagnosis] display, select (Clearing Memory).
6) When "Done. Turn off the ignition switch." pops up, select [OK].
7) Turn Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.
NOTE:
^ If (Clear Memory 21 is selected and performed, DTC and learned control memory are cleared. If (Clear Memory 21 is performed, perform learning control promotion. Programming and Relearning
^ For details concerning the operation procedure, refer to "PC application help for Subaru Select Monitor". Read Diagnostic Trouble Code (DTC)