Operation CHARM: Car repair manuals for everyone.
Home >> Subaru >> 2009 >> Outback F6-3.0L DOHC >> Repair and Diagnosis >> Accessories and Optional Equipment >> Antitheft and Alarm Systems >> Antitheft Motion Sensor >> Description and Operation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Antitheft Motion Sensor: Description and Operation

Impact Sensor

OPERATION

1. IMPACT SENSOR SETTING USING SUBARU SELECT MONITOR
1. Prepare the Subaru Select Monitor kit.






2. Prepare PC with Subaru Select Monitor installed.
3. Connect the USB cable between SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).

NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.

4. Connect the diagnosis cable to SDI.
5. Connect SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).

CAUTION: Do not connect scan tools other than the Subaru Select Monitor.






6. Start the PC.
7. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
8. On the <> display, select the {Integ. unit mode}.
9. Select {ECM customizing}.
10. Make a impact monitor setting.
- When installing: ON
- When removing: OFF

11. Make a impact monitor ON/OFF setting.
- When installing: ON
- When removing: OFF

12. Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.
pro multis · About Operation CHARM