Control Panel (Auto A/C Model)

Control Panel (Auto A/C Model)

REMOVAL

1. Remove the audio assembly.
2. Remove the six screws.

NOTE: When working with the removed audio assembly with its back facing down, place wooden blocks between the audio assembly and the workbench to prevent the ground terminal from folding.






3. Use a fine flat tip screwdriver to lift the hooks in 10 locations gradually. Starting from the sides, proceed to loosen the lower hooks, then the upper hooks, then remove.






4. Pull the panel straight out to remove.

CAUTION: Be careful not to touch the circuit board of the panel to prevent damage by static electricity.

INSTALLATION

1. After attaching the hooks, push the center of the panel by hand and secure the connection between the circuit board and the connector.
2. Install in the reverse order of removal.