Automatic Transmission/Transaxle: Adjustments
Select CableADJUSTMENT
1. Set the vehicle on a lift.
2. Shift the select lever to "N" range.
3. Lift up the vehicle.
4. Remove the rear exhaust pipe and muffler.
- SOHC model
- DOHC turbo model
- DOHC 3.0 L model
5. Remove the heat shield cover.
6. Loosen the adjusting nuts on both sides.
7. Turn adjusting nut B until it lightly touches the connector.
8. Set a spanner wrench to adjusting nut B so that it does not rotate, and then tighten the adjusting nut A.
Tightening torque: 7.5 N-m (0.8 kgf-m, 5.5 ft-lb)
9. After the completion of adjustment, confirm that the select lever operates normally at all ranges.
10. Install in the reverse order of removal.