Navigation System: Testing and Inspection
Navigation SystemINSPECTION
NOTE: If there are no problems in the following "CHECK NAVIGATION OPERATION", "CHECK DVDROM", "CHECK CONNECTION" and "CHECK EACH VEHICLE SIGNAL", check the navigation system circuit.
1. CHECK THE OPERATION OF THE NAVIGATION
Start the engine, and then inspect that the opening screen is displayed.
Standard value: The opening screen should be displayed.
OK: Normal
NG: If the screen is not displayed, check that the map disc is inserted correctly. Or, check the connection of the power supply connector at the backside of the navigation unit. If there are no problems in the connecting lines or the lines were repaired, check that the opening screen is displayed.
At this point, if the display is not viewable, the unit is defective.
2. CHECK EACH CONNECTION
1. 1) With the main power OFF, press and hold the button (c) for 3 seconds or more while pressing the buttons (a) and (b) simultaneously.
NOTE: Pressing the button (a) for 3 seconds or more, or turning the ignition switch from ACC OFF to ON position can exit the diagnostic mode.
2. Line Diag screen is displayed.
3. Check the connection status for each item listed in "Connectivity Check" displayed on the left of the screen.
OK: Each connection device is connected properly.
NG: No connection or abnormal connection is detected.
4. Check the connection status of the connector. If there are no problems, the connection device or unit could be faulty.
3. CHECK EACH VEHICLE SIGNAL
1. With the main power OFF, press and hold the button (c) for 3 seconds or more while pressing the buttons (a) and (b) simultaneously.
NOTE: Pressing the button (a) for 3 seconds or more, or turning the ignition switch from ACC OFF to ON position can exit the diagnostic mode.
2. Line Diag screen is displayed.
3. Check the connection status for each item listed in "Vehicle Signal Check" displayed on the right of the screen.
- CHECK ILLUMINATION
NOTE: Before starting inspections, turn the ignition switch to ON.
1. Turn the lighting switch to level 1.
Make sure that the bright switch is not turned ON at this time.
2. Make sure that "ON" lights in ILL+ and then the screen becomes dim.
ON: Normal.
OFF: Abnormal. Check the signal line connection. If there are no problems, the unit could be faulty.
- CHECK SPEED SENSOR
NOTE:
- Before starting inspections, check the safety around the vehicle.
- Lift up the vehicle as necessary.
- When the diagnostic trouble code is input in the VDCCM, perform the Clear Memory operation.
1. Drive the vehicle at 9 km/h (6 mph) or more.
2. Check that "ON" is displayed in SPD.
ON: Normal.
OFF: Vehicle speed is less than 7 km/h (4 mph), or malfunction is detected in the signal line. Check the signal line connector. If there are no problems, the unit could be faulty.
- CHECK PARKING BRAKE SIGNAL
1. Pull parking brake lever.
2. Check that "ON" is displayed in PKB.
ON: Normal.
OFF: Abnormal. Check the signal line connector. If there are no problems, the unit could be faulty.
- CHECK BACK SENSOR
NOTE: Before starting inspections, check the safety around the rear end of the vehicle and then turn the ignition switch to ON.
1. Pull the parking brake and depress the brake, then put the gear in reverse.
2. Make sure that "ON" is displayed in REV.
ON: Normal.
OFF: Abnormal. Check the signal line connector. If there are no problems, the unit could be faulty.