Backup Lamp: Testing and Inspection
Back-up Light SystemINSPECTION
1. CHECK BACK-UP LIGHT SWITCH (MT MODEL)
1. Disconnect the back-up light switch connector.
2. Measure the resistance between back-up light switch terminals.
Preparation tool: Circuit tester
3. Replace the back-up light switch if the inspection result is not within the standard value.
2. CHECK INHIBITOR SWITCH (AT/CVT MODEL)
1. Disconnect the inhibitor switch connector.
2. Measure the resistance between inhibitor switch terminals.
Preparation tool: Circuit tester
3. Replace the inhibitor switch if the inspection result is not within the standard value.