Manifold Pressure/Vacuum Sensor: Service and Repair
Manifold Absolute Pressure SensorREMOVAL
1. Disconnect the ground cable from battery.
2. Remove the cover (A) and clip (B) from air intake boot assembly.
3. Loosen the clamp (A) which connects the air intake boot assembly and air cleaner case.
4. Loosen the clamp (B) which connects the air intake boot assembly and throttle body.
5. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.
6. Disconnect the connector (A) from the manifold absolute pressure sensor, and remove the manifold absolute pressure sensor from the multi-function duct.
INSTALLATION
Install in the reverse order of removal.
NOTE: Use new O-rings.
Tightening torque: 2 N.m (0.2 kgf-m, 1.5 ft-lb)
NOTE: Align the clamp hole with the protrusion of the air intake boot assembly.
Tightening torque: Clamp (A), (B) 3 N.m (0.3 kgf-m, 2.2 ft-lb)
