Air Cleaner Housing: Service and Repair

Air Cleaner Case

REMOVAL
1. Disconnect the ground cable from battery.






2. Remove the air intake duct.
3. Disconnect the power steering oil pressure hose (suction hose) from the clip on the side of air cleaner case (rear).






4. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B).






5. Loosen the clamp (A) which connects the air cleaner case (rear) and air intake boot assembly, and then remove the clip (B) from the air cleaner case (front).






6. Remove the air cleaner case (rear) and air cleaner element.






7. Remove bolts (A) and nuts (B) which secure the air cleaner case (front) to the body, and remove the air cleaner case (front).






INSTALLATION

1. Install the bolt (A) and nut (B) which secure the air cleaner case (front) to the body.

Tightening torque:
Bolt (A) 6 N.m (0.6 kgf-m, 4.4 ft-lb)
Nut (B) 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)






2. Install the air cleaner case (rear) and air cleaner element.

NOTE: When installing the air cleaner case (rear), align the protrusion of the air cleaner case (rear) to the hole on the air cleaner case (front) to install.






3. Attach the clip (B) to the air cleaner case (front), and tighten the clamp (A) connecting the air cleaner case (rear) and air intake boot assembly.

Tightening torque: Clamp (A) 3 N.m (0.3 kgf-m, 2.2 ft-lb)






4. Connect the connector (A) to the mass air flow and intake air temperature sensor and secure the harness with clip (B).






5. Connect the power steering oil pressure hose suction hose) to the clip on the side of air cleaner case (rear).






6. Install the air intake duct.
7. Connect the battery ground terminal.