Adjustment
Select CableADJUSTMENT
1) Shift the select lever to "N" range.
2) Lift up the vehicle.
3) Remove the front exhaust pipe and rear exhaust pipe.
^ 2.5 L non-turbo model
^ 3.6 L model
4) Remove the heat shield cover.
5) Loosen the nuts on both sides.
6) Turn the nut B until it lightly touches the connector.
7) Set a spanner wrench to the nut B so that it does not rotate, and then tighten the nut A.
Tightening torque:
7.5 Nm (0.8 kgf-m, 5.5 ft-lb)
8) After the completion of adjustment, confirm that the select lever operates normally at all ranges.
9) Install in the reverse order of removal.