Operation CHARM: Car repair manuals for everyone.
Home >> Subaru >> 2012 >> Outback F4-2.5L SOHC >> Repair and Diagnosis >> Transmission and Drivetrain >> Continuously Variable Transmission/Transaxle >> Wiring Harness >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Wiring Harness: Service and Repair

Transmission Harness

REMOVAL

1) Remove the transmission from the vehicle.
2) Prepare for overhaul.
3) Remove the transmission harness ground terminal and remove the harness connectors from front wheel speed sensor and secondary speed sensor.





4) Remove the harness connectors from inhibitor switch, primary speed sensor and secondary pressure sensor.





5) Remove the transmission harness stay.





6) Remove transmission harness connector and inhibitor harness connector from harness stay.
7) Remove the control valve body.
8) Remove the mounting bolt to pull out the bushing of transmission harness from transmission case round hole.





9) Remove the harness clip from transmission assembly.

INSTALLATION

Install in the reverse order of removal.

NOTE:
^ Use new O-rings.
^ Do not impact or bend the transmission harness because it has the oil temperature sensor inside.
^ Install the transmission ground terminal approximately at an angle of 45°.

Tightening torque:
T1: 5 Nm (0.5 kgf-m, 3.7 ft-lb)
T2: 16 Nm (1.6 kgf-m, 11.8 ft-lb)




pro multis · About Operation CHARM