Rear Washer

Rear Washer

REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the rear gate upper trim.
1. Remove the claws on the trim edge.
2. Disconnect the claws in the center of trim, and remove the rear gate upper trim.






3. Remove the high-mounted stop light.
1. Remove the nut.






2. Disconnect the connector and remove the high-mounted stop light.






4. Remove the rear washer nozzle.

CAUTION: Before removing, apply protective tape to the body panel and used tools not to damage the rear gate panel.

1. Push the claw using a flat tip screwdriver, etc.
2. When the washer nozzle lifts up, pull out the nozzle using a clip remover, etc.
3. Disconnect the washer hose and remove the washer nozzle.






INSTALLATION

1. Install each part in the reverse order of removal.

Tightening torque:
High-mounted stop light assembly: 4.5 N.m (0.46 kgf-m, 3.3 ft-lb)

2. Check the washer nozzle position.