Shaft Bearing / Oil Seal

SHAFT BEARING/OIL SEAL
REMOVAL





1. Remove drive shaft assembly.
Refer to item DRIVE SHAFT REMOVAL (LEFT and RIGHT). Drive Shaft
For right side shaft bearing/oil seal removal, drain differential gear oil.





2. Remove left drive shaft by using tire lever.
3. Remove left side strut.





4. Remove oil seal, using plain screw driver.
5. Remove circlip.





6. Remove bearing, using special tools (A) and (B).
Special Tool
(A): 09941-64510
(B): 09930-30102

INSTALLATION





1. Clean drive shaft oil seal and then apply lithium grease.
"A": Grease 99000-25010
Check oil seal for breakage or deterioration. Replace it as necessary.





2. Drive in drive shaft bearing with special tool (A) (on left hand side).
Special Tool (A): 09913-75520
3. Install circlip.





4. Drive in oil seal with special tools (B) and (C).
Special Tool
(B): 09951-16090
(C): 09924-74510

NOTE: As depth to which oil seal should be driven into axle housing is different between the left and right, be sure to check stamped marks on special tool (B) and drive each oil seal to corresponding mark.





5. Install left drive shaft.
6. Install left side strut.
7. Install drive shaft assembly. Refer to DRIVE SHAFT INSTALLATION. Drive Shaft
8. Fill specified differential gear oil into differential case to specified level.