Rear Upper Valve Body

REAR UPPER VALVE BODY

DISASSEMBLY





1. Take out 6 valve body balls.





2. With 3 - 2 kickdown control valve plug pressed with finger, take out needle roller with magnet. Then remove 3 - 2 kickdown control valve plug, clutch sequence valve and reverse brake sequence valve spring.





3. With shift valve plug pressed with finger, take out shift valve retainer with magnet and then remove shift valve plug and 3 - 4 shift valve spring.





4. Remove 2 plate bolts. Then remove rear upper valve body plate and rear upper valve body gasket and take out 1 - 2 shift valve and shift valve spring.





5. With shift valve plug pressed with finger, remove valve retainer with magnet and then remove shift valve plug, 2 - 3 shift valve and shift valve spring.

ASSEMBLY
Assemble each component by reversing disassembly procedure and noting following points.








- Coil outer diameter and free length of each valve sprig should be as listed. Be sure to use each one of correct size.





- Use new rear upper valve body gasket.
- Tighten plate bolt to specified torque.
Plate bolt tightening torque:
5.5 Nm (0.55 kg-m, 4.0 ft. lbs.)