P0101

WIRING DIAGRAM

Detecting Condition/Trouble Area:

DTC CONFIRMATION PROCEDURE

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 person, a driver and a tester, on a level road.

NOTE:
Check to make sure that following conditions are satisfied when using this "DTC CONFIRMATION PROCEDURE".

Intake air temp.: -8 °C (18 °F) or higher
Engine coolant temp.: -8 - 110 °C (18 - 230 °F)
Altitude (barometric pressure) : 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)

1. Connect scan tool to DLC with ignition switch OFF
2. Turn ON ignition switch and clear DTC, pending DTC and freeze frame data by using scan tool and start engine.
3. Increase vehicle speed to 55 km/h (35 mph).
4. Keep driving above vehicle speed for 5 min (Change of vehicle speed is permitted in this step).
5. Stop vehicle and run engine at idle speed for 1 min.
6. Increase vehicle speed and keep engine speed at 2,500 r/min or more in proper gear.
7. Keep driving above vehicle speed and engine speed for 30 sec or more.
8. Stop vehicle and check pending DTC by using scan tool.

Steps 1 - 3:

TROUBLESHOOTING