P1717

WIRING DIAGRAM




DTC DETECTING CONDITION AND TROUBLE AREA

DTC CONFIRMATION PROCEDURE

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester.

NOTE: Check to make sure that the following conditions are satisfied when using this DTC CONFIRMATION PROCEDURE.

- Intake air temp.: -14 °C, 6.8 °F or higher
- Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)

1. Turn ignition switch OFF and connect scan tool to DLC.
2. Clear DTC with ignition switch ON.
3. Start engine and shift select lever to "D" range.
4. Increase vehicle speed to higher than 25 MPH, 40 KPH and then stop vehicle.
5. Repeat above step 4 - 9 times.
6. Shift selector lever to "2" range and repeat above step 4 and 5).
7. Shift selector lever to "L" range and repeat above step 4 and 5).
8. Check DTC and pending DTC.




TROUBLESHOOTING