Center Shaft and Bearing Service

DISASSEMBLY





1. By using hydraulic press, draw out center shaft from center bearing.
2. Remove oil seals from center bearing support.





3. Remove bearing support circlips.
4. Remove center bearing from center bearing support.
Special Tool
(A): 09900-06108

ASSEMBLY





Install center shaft by reversing removal procedure and noting following points.
- When installing bearing support circlip, make sure that it fits in circlip groove in center bearing support securely as shown.





- When installing oil seals, use care so that it is in proper direction referring to figure.
"A" : Grease 99000-25010





- Press-fit center shaft from left oil seal side.