Scan Tool Data

Scan Tool Data

The parameter data below are values measured with the scan tool when the normally operating vehicle. Confirm that the parameter of SUZUKI scan tool within 15 minutes after performing the following procedure.
1. Turn ignition switch to OFF position.
2. Connect SUZUKI scan tool to DLC.
3. Drive vehicle at 40 km/h (25 mph) for 2 minutes or more.
4. Stop vehicle.
5. Apply parking brake and block wheels.
6. Turn ignition switch to ON position.
7. Confirm that no DTC is detected.
8. Adjust each tire pressure to 230 kPa.





NOTE: Each tire pressure sensor is numbered and that number is assigned in the order as its ID code is registered in BCM. It does not indicate the tire position (LF, RF, LR and RR). Check what number of the tire pressure sensor is assigned to which tire, referring to How to Identify Tire Pressure Sensor Number.