Removal and Replacement
Generator Removal and InstallationRemoval
1. Disconnect negative (-) cable from battery.
2. Remove intake manifold.
3. Remove accessory drive belt.
4. Disconnect "B" terminal wire (1) and connector (2) from generator (3).
5. Remove generator (3).
Installation
Reverse removal procedure noting the following.
Tighten generator bolts, "B" terminal wire nut and power steering pump stay bolt to specified torques.
Tightening torque
"B" terminal wire nut (a): 11 N.m (1.1 kg-m, 8.5 lbf-ft)
Generator bolt (b): 45 N.m (4.6 kg-m, 33.5 lbf-ft)
Power steering pump stay bolt (c): 25 N.m (2.5 kg-m, 18.5 lbf-ft)
