Rear
REMOVAL
1. Disconnect speed sensor connector.
2. Remove speed sensor.
a. Remove the clamp bolt, the clamp nut and the 5 clips holding the sensor wire harness from the axle and the fuel tank.
HINT:
- When installing the rear sensor wire harness, never use the removed resin clips, which are service parts.
- When replacing clips, set up new resin clips at the same angle of the removed resin clips.
- When removing a resin clip, take care so that the removing tool is not caught on the grommet or wire.
Torque: 13 Nm (9 ft. lbs.)
b. Remove the speed sensor from the axle carrier.
Torque: 8.0 Nm (71 inch lbs.)
INSTALLATION
Installation is in the reverse order of removal. After installation, check speed sensor signal.