Disassembly and Reassembly

DISASSEMBLY
1. 2WD: REMOVE GREASE CAP
a. Mount the axle hub in a soft jaw vise.

HINT: Close the vise until it holds hub bolts. Do not tighten further.

b. Using a screwdriver, remove the grease cap.
2. 4WD: REMOVE OIL SEAL (INSIDE)
a. Mount the axle hub in a soft jaw vise.

HINT: Close the vise until it holds hub bolts. Do not tighten further.

b. Using a screwdriver, remove the oil seal (inside).





3. REMOVE AXLE HUB FROM STEERING KNUCKLE
a. Remove the 4 bolts and shift the dust cover towards the hub side (outside).
b. Using SST, remove the axle hub from the steering knuckle.
SST 09710-30021 (09710-03051), 09950-40011 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04031, 09957-04010, 09958-04011)
c. Remove the dust cover from the steering knuckle.
d. Remove the bearing spacer and ABS speed sensor rotor (w/ABS) /spacer (w/o ABS).

NOTICE: Take care not to scratch the serration of the speed sensor rotor.

4. REMOVE OIL SEAL (OUTSIDE)
Using a screwdriver, remove the oil seal (outside) from the steering knuckle.





5. REMOVE BEARING FROM STEERING KNUCKLE
a. Using snap ring pliers, remove the snap ring.
b. Using SST and a press, remove the bearing from the steering knuckle.
SST 09950-60020 (09951-00810), 09950-70010 (09951-07150)

REASSEMBLY





1. INSTALL NEW BEARING
a. Using SST and a press, install a new bearing to the steering knuckle.
SST 09527-17011, 09950-60020 (09951-00910)
b. Using snap ring pliers, install a new snap ring.





2. INSTALL NEW OIL SEAL (OUTSIDE)
a. Using SST and a plastic hammer, install a new oil seal (outside).
SST 09223-15030, 09527-17011
b. Coat MP grease to the oil seal lip.





3. INSTALL AXLE HUB TO STEERING KNUCKLE
a. Install the dust cover to the steering knuckle with the 4 bolts.
Torque: 18 Nm (185 kgf-cm, 13 ft. lbs.)
b. Using SST and a press, install the axle hub to the steering knuckle.
SST 09649-17010
4. INSTALL ABS SPEED SENSOR ROTOR (w/ ABS)/SPACER (w/o ABS)

NOTICE: Do not scratch the serration of the speed sensor rotor.





5. INSTALL BEARING SPACER
Using SST and a press, install the bearing spacer.
SST 09950-60010 (09951-00650), 09950-70010 (09951-07150)
6. 2WD: INSTALL GREASE CAP





7. 4WD: INSTALL NEW OIL SEAL (INSIDE)
a. Using SST and a plastic hammer, install a new oil seal (inside).
SST 09527-17011

HINT: Lightly strike the SST on its circumference evenly.

b. Coat MP grease to the oil seal lip.