Removal and Replacement

FRONT BUMPER

Front Bumper:

Front Bumper:

REMOVAL

1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE FRONT BUMPER ASSEMBLY





a. Using a clip remover, remove the 3 clips.
b. Remove the 4 bolts and 9 screws.
c. with Fog light:
1. Disconnect the fog light assembly connectors.





d. Using a screwdriver, disengage the 8 claws and remove the front bumper assembly.

HINT: Tape the screwdriver tip before use.

INSTALLATION

1. INSTALL FRONT BUMPER ASSEMBLY





a. Install the front bumper assembly with the 8 claws.
b. with Fog light:
1. Connect the fog light assembly connectors.





c. Install the 4 bolts and 9 screws.

Torque:
Bolt: 8.0 N.m (82 kgf.cm, 71 in.lbf)
Screw: 3.0 N.m (31 kgf.cm, 27 in.lbf)

d. Install the 3 clips.

2. CONNECT BATTERY NEGATIVE TERMINAL
3. VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT
4. VEHICLE PREPARATION FOR FOG LIGHT AIM ADJUSTMENT
5. INSPECT FOG LIGHT AIMING
6. ADJUST FOG LIGHT AIMING
7. PERFORM INITIALIZATION
Some systems need initialization when disconnecting the cable from the negative battery terminal.