Removal

EXTERIOR: FRONT DOOR GLASS WEATHERSTRIP: REMOVAL

REMOVAL
HINT: The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL
HINT: Use the same procedure as for the RH side Disassembly.

3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
HINT: Use the same procedure as for the RH side Disassembly.

4. REMOVE FRONT DOOR NO. 2 SERVICE HOLE COVER
HINT: Use the same procedure as for the RH side Disassembly.

5. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY





(a) for Driver Side:
(1) Provisionally install the power window regulator master switch.
(b) for Front Passenger Side:
(1) Provisionally install the power window regulator switch.
(c) Close the door glass.
(d) Disconnect the connector.
(e) Remove the 3 bolts and the outer rear view mirror.
NOTE: Do not drop or damage the outer rear view mirror when removing the bolts.

6. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY





(a) Apply protective tape to the front door panel in the area around the front door glass outer weatherstrip.





(b) Using a moulding remover, disengage the 8 claws and remove the front door glass outer weatherstrip.