TS and CG Terminal Circuit

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: TS and CG Terminal Circuit

TS and CG Terminal Circuit

DESCRIPTION

In sensor check mode, malfunctions of the speed sensor that cannot be detected when the vehicle is stopped are detected while driving.
Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from OFF to ON.

WIRING DIAGRAM





INSPECTION PROCEDURE
NOTE: When replacing the master cylinder solenoid, perform zero point calibration Programming and Relearning.

PROCEDURE

1. INSPECT DLC3 TERMINAL VOLTAGE (TS)




(a) Turn the ignition switch to ON.
(b) Measure the voltage.
Standard voltage:






OK -- REPLACE MASTER CYLINDER SOLENOID
NG -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3)




(a) Disconnect the skid control ECU connector.
(b) Measure the resistance.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (BODY GROUND - DLC3)




(a) Measure the resistance.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE MASTER CYLINDER SOLENOID