Reassembly

PARKING BRAKE: PARKING BRAKE ASSEMBLY: REASSEMBLY

REASSEMBLY





1. INSTALL PARKING BRAKE SHOE LEVER
(a) Using a feeler gauge, measure the clearance.
Standard clearance:
Less than 0.25 mm (0.0098 in.)
If the clearance is not within the specifications, replace the shim with one of the correct size.






(b) Using pliers, install the parking brake shoe lever and the shim with a new C-washer.
2. APPLY HIGH TEMPERATURE GREASE
(a) Apply high temperature grease to the surface of the backing plate which is in contact with the shoe.
3. INSTALL PARKING BRAKE SHOE





(a) Apply high temperature grease to the adjusting bolt and piece.
(b) Using needle-nose pliers, connect the parking brake cable to the parking brake shoe lever.





(c) Install the No. 1 shoe, hold down spring pin, hold down compression spring and 2 hold down spring cups.
(d) Install the return tension spring and shoe adjusting screw set.
(e) Install the No. 2 shoe, hold down spring pin, hold down compression spring and 2 hold down spring cups.
4. INSTALL PARKING BRAKE SHOE STRUT
(a) Attach the compression spring and parking brake shoe strut to the No. 2 and No. 1 shoes.





5. INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING
(a) Using needle-nose pliers, install the 2 return tension springs.
HINT: First install the front side spring then install the rear side spring.

6. CHECK PARKING BRAKE INSTALLATION
(a) Check that each part is installed properly.




NOTE: There should be no oil or grease adhering to the friction surfaces of the shoe lining or the disc.