M/T - Clutch Release Bearing Squeak Or Rattle
T-SB-0365-10December 22, 2010
6-Speed Manual Clutch Release Bearing Squeak or Rattle Noise
Service Category
Drivetrain
Section
Manual Transmission/Transaxle
Market
USA
Applicability
Introduction
Some manual transmission equipped FJ Cruiser and V6 Tacoma vehicles may exhibit a squeak or rattle noise from the transmission area when the clutch pedal is released. Changes have been made to the clutch system to eliminate this noise. Follow the procedure in this bulletin to address this condition.
Warranty Information
APPLICABLE WARRANTY
^ This repair is covered under the Toyota Powertrain Warranty. This warranty is in effect for 60 months or 60,000 miles, whichever occurs first, from the vehicle's in-service date.
^ Warranty application is limited to occurrence of the specified condition described in this bulletin.
Parts Information
Required Tools & Equipment
Repair Procedure Overview
1. Confirm that the noise is only present with the clutch pedal released and goes away with the clutch pedal depressed.
2. Remove the transmission.
3. Replace the clutch release cylinder clutch release fork support clutch release bearing and inspect the clutch cover.
4. Reinstall the transmission.
5. Test drive the vehicle and confirm the noise is no longer present.
Repair Procedure
1. Confirm there is a squeak or rattle noise from the transmission assembly when the clutch pedal is fully released.
A. Is the noise coming from the transmission assembly?
^ YES - Go to question B.
^ NO - This TSB does NOT apply. Continue diagnosis to locate the source of the noise.
B. Does the noise go away when the clutch pedal is depressed?
^ YES - Go to step 2.
^ NO - This TSB does NOT apply. Continue diagnosis to locate the source of the noise.
2. Remove the clutch release cylinder then the transmission assembly.
Refer to the Technical Information System (TIS) applicable model and model year Repair Manual:
3. Replace the clutch release fork support and clutch release bearing.
Refer to TIS applicable model and model year Repair Manual:
4. Inspect the clutch cover assembly for wear and replace the clutch cover assembly if wear is excessive. Confirm clutch cover finger heights are even.
5. Install the NEW clutch release cylinder and transmission assembly.
Refer to TIS applicable model and model year Repair Manual:
6. Test drive the vehicle and confirm the noise is eliminated.