Navigation System

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: 01-D5: Absence of Registration Unit

DTC 01-D5 - Absence of Registration Unit

DTC 01-D8 - No Response for Connection Check

DTC 01-D9 - Last Mode Error

DTC 01-DA - No Response Against ON / OFF Command

DTC 01-DB - Mode Status Error

DTC 01-DE - Slave Reset

DESCRIPTION





HINT:
- *1: Even if no fault is present, this trouble code may be stored depending on the battery condition or engine start voltage.
- *2: If the power connector is disconnected after the engine starts, this code is stored after 180 seconds.
- *3: If it is reported that the device does not exist during verification, check the power source circuit and AVC-LAN circuit for the device.

NOTICE:
- Before starting troubleshooting, be sure to clear DTCs to clear codes stored due to the reasons described in Hint above. Then, check for DTCs and troubleshoot according to the output DTCs.
- The navigation receiver is the master unit.
- Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.

INSPECTION PROCEDURE

NOTE: Be sure to read Description before performing the following procedures.

PROCEDURE

1. CHECK "NAVIGATION RECEIVER COMMUNICATION ERROR" IN FLOWCHART
(a) Refer to the navigation receiver communication error Navigation Receiver Assembly Communication Error.
NEXT -- END