Bluetooth Handsfree Module Communication Error
AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: Bluetooth Handsfree Module Communication Error
Bluetooth Handsfree Module Communication Error
INSPECTION PROCEDURE
PROCEDURE
1. IDENTIFY COMPONENT SHOWN BY SUB-CODE
(a) Enter the diagnostic mode.
(b) Press the preset switch "3" to change to "Detailed Information Mode".
(c) Identify the component shown by the sub-code.
HINT:
- "190 (radio receiver)" is the component shown by the sub-code in the example shown in the illustration.
- For details of the DTC display, refer to "DTC Check/Clear" Reading and Clearing Diagnostic Trouble Codes.
NEXT -- Continue to next step.
2. CHECK COMPONENT SHOWN BY SUB-CODE
(a) Select the component shown by sub-code.
HINT: The "Bluetooth" handsfree module is built into the radio receiver assembly. If there is a problem between the "Bluetooth" handsfree module and radio receiver assembly, replace the radio receiver assembly.
Component Table
B -- REPLACE RADIO RECEIVER ASSEMBLY
A -- Continue to next step.
3. CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
(a) Inspect the power source circuit of the component shown by the sub-code.
If the power source circuit is operating normally, proceed to the next step.
Component Table
HINT: *: w/ Rear Seat Entertainment System
NEXT -- Continue to next step.
4. INSPECT RADIO RECEIVER ASSEMBLY
(a) Disconnect the I4 and I8* radio receiver assembly connectors.
HINT: *: w/ Rear Seat Entertainment System
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
HINT: *: w/ Rear Seat Entertainment System
(c) Reconnect the radio receiver assembly connectors.
NG -- REPLACE RADIO RECEIVER ASSEMBLY
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR ("BLUETOOTH" HANDSFREE MODULE - COMPONENT SHOWN BY SUB-CODE)
HINT:
- Start the check from the circuit that is near the component shown by the sub-code first.
- For details of the connectors, refer to "Terminals of ECU" Pinout Values and Diagnostic Parameters.
(a) Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the "Bluetooth" handsfree module and the component shown by the sub-code.
(1) Disconnect all connectors between the "Bluetooth" handsfree module and the component shown by the sub-code.
(2) Check for an open or short in the AVC-LAN circuit between the "Bluetooth" handsfree module and the component shown by the sub-code.
OK:
There is no open or short circuit.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
6. REPLACE COMPONENT SHOWN BY SUB-CODE
(a) Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.
OK:
Same problem does not occur.
NG -- REPLACE RADIO RECEIVER ASSEMBLY (BUILT-IN "BLUETOOTH" HANDSFREE MODULE)
OK -- END