Removal

SEAT: FRONT SEAT ASSEMBLY (for Manual Seat): REMOVAL

REMOVAL

HINT:
- Use the same procedure for the LH side and RH side.
- The procedure listed below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
- When disconnecting the cable some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE FRONT SEAT HEADREST ASSEMBLY
3. REMOVE SEAT TRACK COVER INNER LH
(a) Operate the seat track adjusting handle to move the seat to the foremost position.





(b) Disengage the 2 claws and remove the seat track cover.
4. REMOVE SEAT TRACK COVER LH





(a) Disengage the 2 claws and remove the seat track cover.
5. REMOVE FRONT SEAT ASSEMBLY LH





(a) Remove the 2 bolts.
(b) Operate the seat track adjusting handle to move the seat to the rearmost position.





(c) Remove the 2 bolts.
(d) Operate the seat track adjusting handle to move the seat to the center position.
(e) Disconnect the seat wire connectors under the seat.
(f) Remove the front seat.

NOTE: Be careful not to damage the vehicle body.