Reassembly

BRAKE (REAR): REAR BRAKE: REASSEMBLY

REASSEMBLY

1. INSTALL PISTON SEAL





(a) Apply a light layer of lithium soap base glycol grease to the entire inner and outer circumference of a new piston seal.
(b) Install the piston seal to the disc brake cylinder.
2. INSTALL CYLINDER BOOT





(a) Apply a light layer of lithium soap base glycol grease to the entire inner and outer circumference of a new cylinder boot.
(b) Apply a light layer of lithium soap base glycol grease to the entire outer circumference of the rear disc brake piston where it contacts the rear disc brake cylinder.
(c) Install the cylinder boot to the rear disc brake piston.
(d) Install the rear disc brake piston to the rear disc brake cylinder assembly.
3. INSTALL REAR DISC BRAKE PISTON
(a) Install the cylinder boot to the disc brake cylinder.

NOTE: Install the boot securely into the groove of the disc brake cylinder.





(b) Push in the piston by hand and install the cylinder boot into the groove of the piston.

NOTE: Install the boot securely into the grooves of the piston.

4. TEMPORARILY INSTALL REAR DISC BRAKE BLEEDER PLUG
(a) Temporarily install the bleeder plug to the disc brake cylinder.

HINT: The bleeder plug will be tightened to the torque specification in the "BLEED AIR FROM BRAKE LINE" procedure.

5. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP