Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: INSTALLATION

INSTALLATION

CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

1. INSTALL STEERING PAD

NOTE: Do not use a steering pad that has been dropped.





(a) Confirm that the ignition switch is turned off.
(b) Confirm that the negative battery terminal is disconnected.

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the horn terminal.
(d) Connect the airbag connector.

NOTICE:
- Match the color of the airbag connector with that of the steering pad assembly, and install the airbag connector.
- Securely lock the locking button.

(e) Install the steering pad.





(f) Using "TORX" socked wrench T30, tighten the 2 screws.
Torque: 8.8 Nm (90 kgf-cm, 78 in-lbf)
2. INSTALL LOWER NO. 3 STEERING WHEEL COVER





(a) Attach the 2 claws to install the cover.
3. INSTALL LOWER NO. 2 STEERING WHEEL COVER





(a) Attach the 2 claws to install the cover.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. INSPECT STEERING PAD
(a) With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, small cracks or marked discoloration on the steering pad top surface or in the grooved portion.
(b) Check that the horn sounds.
If the horn does not sound, inspect the horn system.
6. CHECK SRS WARNING LIGHT Diagnosis System