Speaker Circuit (Built-In Amplifier)
AUDIO / VISUAL: AUDIO AND VISUAL SYSTEM (for Regular Cab and Double Cab): Speaker Circuit (Built-in Amplifier)
Speaker Circuit (Built-in Amplifier)
DESCRIPTION
The stereo component amplifier sends sound signals to the speaker.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK SPEAKER
(a) Check the malfunctioning speakers.
Result:
HINT: *: for Double Cab
B -- INSPECT REAR NO. 1 SPEAKER
A -- Continue to next step.
2. CHECK SPEAKER
(a) Check the malfunctioning speakers.
Result:
B -- INSPECT FRONT NO. 1 SPEAKER
A -- Continue to next step.
3. INSPECT FRONT NO. 2 SPEAKER
(a) Disconnect the K11 and K13 speaker connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
for LH
for RH
Result:
C -- REPLACE FRONT NO. 2 SPEAKER
B -- REPLACE FRONT NO. 2 SPEAKER
A -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - FRONT NO. 2 SPEAKER)
(a) Disconnect the K1 receiver connector.
(b) Disconnect the K11 and K13 speaker connectors.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
for LH
for RH
Result:
C -- REPLACE RADIO RECEIVER
B -- REPLACE RADIO RECEIVER
A -- REPAIR OR REPLACE HARNESS OR CONNECTOR
5. INSPECT FRONT NO. 1 SPEAKER
(a) Disconnect the M8 and N10 speaker connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Result:
C -- REPLACE FRONT NO. 1 SPEAKER
B -- REPLACE FRONT NO. 1 SPEAKER
A -- Continue to next step.
6. CHECK HARNESS AND CONNECTOR (FRONT NO. 2 SPEAKER - FRONT NO. 1 SPEAKER)
(a) Disconnect the M8, N10, K11 and K13 speaker connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
for LH
for RH
Result:
C -- REPLACE FRONT NO. 2 SPEAKER
B -- REPLACE FRONT NO. 2 SPEAKER
A -- REPAIR OR REPLACE HARNESS OR CONNECTOR
7. INSPECT REAR NO. 1 SPEAKER
(a) Disconnect the O1 and O7 speaker connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPLACE REAR NO. 1 SPEAKER
OK -- Continue to next step.
8. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - REAR NO. 1 SPEAKER)
(a) Disconnect the K2 receiver connector.
(b) Disconnect the O1 and O7 speaker connectors.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
for LH
for RH
Result:
C -- REPLACE RADIO RECEIVER
B -- REPLACE RADIO RECEIVER
A -- REPAIR OR REPLACE HARNESS OR CONNECTOR