TC and CG Terminal Circuit

CRUISE CONTROL: CRUISE CONTROL SYSTEM: TC and CG Terminal Circuit
- TC and CG Terminal Circuit

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)

(a) Disconnect the F50 ECM connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

for 1GR-FE





for 2TR-FE





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures